Erase Current Configuration
Use option 6 to load using the system default configuration and to boot without using the current
startup configuration. Selecting 6 from the Utility menu restores system defaults. Boot Sequence can
then be started by selecting 1 from the Utility menu.
To download software from the Utility menu:
1 On the Utility menu, select
6
and press
[Enter]
.
The following prompt displays:
Are you SURE you want to delete the configuration? (y/n):y
2 The bootup process resumes.
Erase Permanent Storage
Use option 7 to delete the active image from the flash memory. User action is confirmed with a Y/N
question before executing the command.
To delete the backup image from the Utility menu:
1 On the Utility menu, select
7
and press
[Enter]
. The following prompt displays:
Are you SURE you want to delete operational code: image2? (y/n):y
Operational code deleted...
[Utility menu]
2 The bootup process resumes.
Select Boot Method
Use option 8 to select the method used to boot the system (FLASH, Network, or Serial boot). The
default selection is FLASH.
To select the boot method from the Utility menu:
1 On the Utility menu, select
8
and press
[Enter]
. The following prompt displays:
Current boot method: FLASH
1 - Flash Boot
2 - Network Boot
3 - Serial Boot
4 - Exit without change
Select option (1-4):
2 The bootup process resumes.
Activate Backup Image
Use option 9 to activate the backup image. The active image becomes the backup when this option is
selected.
To activate the backup image:
Getting Started
ExtremeSwitching 200 Series: Administration Guide
15
