The Extricom EXWO-404 WLAN System User Guide
13
Table 4. Extricom AP LEDs
LEDs
Color
Description
Radio 1
Green
1
st
Radio is active
Off
1
st
Radio is malfunctioning
Radio 2
Green
2
nd
Radio is active
Off
2
nd
Radio is malfunctioning
LAN
Green (flashing)
Connection to the LAN switch is active
Off
Not active
Power
Green
On/Off
Connecting the Switch and Access Points
Extricom’s switch is connected to the wired LAN and the APs that are located throughout the
office.
To connect the switch and Access Points:
1.
Using a CAT-5e/6 cable, connect the switch RJ-45 LAN connector (located on the front panel
of the switch, (refer to Figure 5) to the LAN switch.
2.
Using a CAT-5e/6cable, directly connect each AP (refer to Figure 5) to one of the switch’s RJ-
45 WLAN connectors.
3.
Connect the power cable to the power connector located on the rear panel of the switch, and
plug the other end of the power cable into a power source.
4.
Verify that the Power LEDs on both the switch and connected APs are green.
Mounting the Access Points (Optional)
Extricom APs can be mounted on the wall. To mount the APs, you will need two stainless steel pan
head 8x1-1/4" self-tapping Phillips screws.
To mount the Access Points:
1.
Place the installation template (refer to
Access Point Mounting Template
on page 48) on the
wall where you want to mount the AP.
2.
Mark the "Point for Drilling" locations on the wall.
3.
Screw the two stainless steel pan head 8x1-1/4" self-tapping Phillips screws into the wall
leaving enough of the screws protruding to enable you to hook the AP over the screw.
4.
Align the holes on the back of the Access Point with the screws and slip the AP into place.
Position the AP so that the connectors are on its bottom left corner.
Summary of Contents for EXSW-400
Page 1: ...Version 1 0 THE EXTRICOM WLAN SYSTEM WIRELESS OFFICE EDITION EXWO 404 USER GUIDE ...
Page 4: ......
Page 20: ......