Symbol Definitions
]
= CR/LF (carriage return and line feed) (hex
0D
0A
)
}
or
|
¦
= Soft carriage return (no line feed) (hex
0D
)
•
= Space
E
or
W
= Escape key (hex
1B
)
X!
= On and off (enable and disable)
0
= Off or disabled
1
= On or enabled
X@
= Extender unit part number:
• Transmitter, MM:
60-1474-11
• HID only Transmitter, MM:
60-1526-11
• Transmitter, SM:
60-1474-12
• HID only Transmitter, SM:
60-1526-12
• Receiver, MM:
60-1474-21
• HID only Receiver, MM:
60-1526-21
• Receiver, SM:
60-1474-22
• HID only Receiver, SM:
60-1526-22
NOTE:
Unless otherwise indicated, commands are
not
case-sensitive.
Command and Response Table for SIS Commands
Command
ASCII Command
(Host to Unit)
Response
(Unit to Host)
Additional Description
Information Requests
Request part number
N
X@
]
Show the extender part number
X@
.
Query firmware version
Q
n.nn
]
Show firmware version, expressed to the
second decimal place.
Example:
Q
1.01
]
The unit firmware version is
1.01
.
Query version and build
*Q
n.nn.nnnn
]
Show firmware version and build number.
Reset
Reset
E
ZXXX
}
Zpx
]
Reset the extender to factory default
values.
Peripheral Emulation (Transmitter Only)
NOTE:
These commands can be issued only to the transmitter.
Set peripheral emulation
E
E
X!
USBC
}
Usbc
E
X!
]
Set peripheral emulation for the FOX T/R
USB Extender Plus to
X!
. The default is
On
.
View peripheral
emulation
E
E
USBC
}
X!
]
FOX T/R USB Extender Plus • Remote Configuration and Control
19
Summary of Contents for 60-1474-11
Page 2: ......
