User’s Guide
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Daisan DMJ Building 6F
3-9-1 Kudan Minami
Chiyoda-ku, Tokyo 102-0074 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
www.extron.com
© 2001 Extron Electronics. All rights reserved.
Active Audio AAP Installation Kit
68-640-01 Rev. A
Printed in the USA
12 01
RGB 138
xi
xi
xi
xi
xi
and 168
xi
xi
xi
xi
xi
5
Route the audio cables through the rear cable clamp
openings of the interface, as shown below.
Connect powered speakers or another audio device to the
included captive screw connectors. Insert the audio device
wires into the captive screw connector and tighten the
captive screws to fasten the wires, then insert the wired
audio connector into the audio output connector of the
Active Audio AAP plate before installing the AAP plate into
the interface.
Connect the sleeve to ground (GND).
Connecting the sleeve to a negative (-)
terminal will damage the audio output circuits.
6
Install the Active Audio AAP adapter into the interface using
the four nuts and replace the interface’s top cover. Mount
the interface in a rack or furniture and connect the power
cords and turn on the devices in the following order: display
and audio output devices, the interface, and input device
(computer).
Unbalanced Output
Tip
See Warning
Sleeve (s)
Tip
See Warning
Balanced Output
Tip
Ring
Sleeve (s)
Tip
Ring
HI
GH
V
OL
TA
GE
CA
UT
IO
N
RGB 138 xi
INP
UT
S
AU
DIO
AN
AL
OG
UN
SW
ITC
HE
D
600 W
AT
TS
M
AX
.
MIN
/MA
X
MB
C
PO
WE
R
UN
IVE
RS
AL
IN
TE
RF
AC
E
W
/AD
SP
Cable Routing
Audio cables are routed through
the rear cable clamp openings
Active Audio AAP Kit
Part number
Active Audio Buffering Unbalanced to
Balanced Stereo Audio Kit
70-110-04
