RGB 138
xi
xi
xi
xi
xi
and 168
xi
xi
xi
xi
xi
Active Audio AAP • Installation
RGB 138
xi
xi
xi
xi
xi
and 168
xi
xi
xi
xi
xi
Active Audio AAP • Installation
Installation
3
2
Extron’s Active Audio Buffering Unbalanced to Balanced Stereo
Audio AAP Installation kit (part #70-110-04) offers Active Audio
AAP connections for Extron’s RGB 138
xi
and RGB 168
xi
universal
analog interfaces.
Active Audio AAP Installation Kit Instructions
These instructions refer to both the RGB 138
xi
and the RGB 168
xi
models.
To install the Active Audio AAP Installation kit, refer to the steps
below, the
RGB 138xi, RGB 168xi User’s Manual
, and the Active
Audio AAP label wiring instructions.
1
Disconnect the power from the interface, remove the
interface from its rack mount or furniture mount position,
and remove the top cover.
2
Remove the blank AAP plate(s) from the interface to
accommodate the double-space Active Audio AAP plate.
RG
B 1
38
xi
INPUTS
AUDIO
ANALOG
UN
SW
ITC
HE
D
60
0 W
AT
TS
M
AX
.
MIN
/MA
X
MBC
PO
WER
UNIVERSAL INTERF
ACE
W /ADSP
Remove #8 Screws
(4 Places) Each Side
and Bracket, if Present
Remove (12)
Screws
Lift Cover
Straight Up
Active Audio AAP power cable
connected to AAP power connector
Active Audio
outputs
The Active Audio AAP plate’s power and audio connections
must be wired before mounting the AAP plate in the
interface. Both the provided Active Audio AAP power cable
and the included captive screw audio connectors are keyed
to prevent incorrect connections.
3
Route the Active Audio power cable under the interface’s
power cable.
4
Connect the interface end of the power cable to the power
connector on the interface’s main board. The connectors are
keyed to prevent an incorrect connection.
Route the Active Audio AAP power cable
under the interface's power supply cable
Connect this power connector to the
interface's power connector
Connect the Active Audio AAP power cable
to the interface's power connector
