AVT 200HD Tuner • Operation
32
You can access the Exec Mode Select menu when any other menu or submenu is displayed.
To select an executive mode:
1.
Press the Menu and Next buttons simultaneously and hold them until the LCD window
displays the
Exec
Mode
Select
menu with the name of the current executive mode
(approximately 3 seconds).
2.
Rotate either Adjustment knob until the desired mode name appears in the LCD
window.
3.
Press the Menu or Next button to return to the default cycle or wait for the LCD display
to time out.
EXEC MODE SELECT
DISABLE
[ANY MENU]
or
Menu + Next
Default
Cycle
•
DISABLE
(Default)
•
COMPLETE
•
VOLUME
ONLY
•
IR
LOCKOUT
Use either Adjustment knob
to select an executive mode.
Menu
Figure 26.
Executive Mode Menu Flow
Using the AVT 200HD IR Remote Control
The optional hand-held AVT 200HD IR Remote Control lets you remotely perform many
of the functions that are also available through the front panel, SIS commands, the
Windows-based control software, or the embedded web pages. The AVT responds to
commands from the remote control as if the corresponding front panel button were pressed
or the corresponding SIS command or software selection were entered.
From a distance of no more than 30 feet (9.1 m), the remote control sends infrared (IR)
signals to the AVT 200HD through the infrared remote sensor, located on the front panel
to the left of the LED channel display. The IR sensor can receive the signal if it is sent from
within a 40 degree arc to the right or left of direct line of sight between the remote control
and the AVT receiver. See the diagram on the next page.
