AXP 64 C AT • Installation
15
Resetting
A recessed button on the rear panel (see
F
, on page 7) initiates a reset
to factory values. Reset clears all processors, level controls, and mixers to the defaults
and initiates a Dante controller reset (see
Dante Controller Configuration
page 23). It also closes all open IP and Telnet connections and all sockets.
To reset the AXP 64 C AT:
1.
With power off, press and hold the rear panel reset button.
2.
Apply power to the device.
3.
Continue to hold the reset button for about 10 seconds until the Ethernet port indicators
blink once.
NOTE:
Alternatively, you can reset the AXP by entering the
ZXXX
SIS reset command
Summary of Contents for AXP 64 C AT
Page 6: ......