2
DPH 101 • User Guide (Continued)
Mounting
Use the included hook and loop tape to attach the DPH 101 to the application surface.
Cabling
12V
0.2 A MAX
POWER
DPH
101
SIG
DP IN
DPH 101
HDMI OUT
SIG
Rear
Front
A
B
C
Figure 1.
DPH 101 Panels
A
DC power input
— Wire the external 12 VDC power supply as shown in figure 2 and connect it to the two-pole captive screw
Power connector.
SECTION A–A
Ridges
Smooth
Power Supply Output Cord
A
A
3/16"
(5 mm) Max.
Figure 2.
Power Connection
NOTE:
See the
Attention
on the next page for important information.
The DPH 101 can also share power with an Extron switcher or similar device (as shown in figure 3).
PS 1210 C
DPH 101
SW4 HDMI
12V
0.2 A MAX
POWER
DPH
101
SIG
DP IN
0.5A MAX
POWER
12V
1
Tx Rx
1
2 3 4 +V
1
2 3 4 G
RS-232 AUTO
CONTACT
TALLY OUT
SW4 HDMI
2
3
4
INPUTS
OUTPUT
REMOTE
DC Power
Output
DC Power
Shared
Figure 3.
Sharing Power with an Extron Switcher
B
DP input
— Connect a Dual-Mode DisplayPort input device to the DP input. The DPH 101 equalizes DisplayPort signals up
to 15 feet.
NOTE:
The DPH 101 can be used with Extron DisplayPort Architectural products, such as the DisplayPort F-F
Architectural Adapter Plate (see
figure 5
on page 4). However, it is not recommended to use more than one DP-DP
pigtail in an application.
C
HDMI output
— Connect an HDMI output device to the HDMI output. The DPH 101 reconditions HDMI signals up to 15 feet.
NOTE:
Extron recommends using HDMI Pro Series cables for 300 Mhz pixel clock (4K/UHD) signals.
