Extron electronics Hideaway HSA 400 US/domestic, User Manual

HSA 400/402 Series • Installation

HSA 400/402 Series • Installation

Installation, cont’d

Routing the AAP Cables

The AAP cables must have freedom of movement to permit

opening and closing the surface mount enclosure.  At the same

time, they need to be restrained to prevent them from rubbing

against the edges of the enclosure cable access hole in the

underside of the surface mount enclosure.  Rubbing against the

cable access hole edges can damage the cables.  Route and

secure the AAP cables as follows:

1

.

Open the top panel to extend the AAP cables to their

maximum pull.

2

.

Experiment with AAP cable positioning to ensure that the

cables do not rub against the edges of the AAP cable hole

and to ensure that the cable pull does not restrict the

movement of the top panel.  Figure 2-9 shows the cables

routed to the side, which proved effective in tests at

Extron.

3.

Secure the AAP cables to the tie-down holes with tie wraps

in the clamshell and the enclosure in the locations shown

on figure 2-9.

Secure the AAP cables at the circled locations.

Rear View into HSA and Clamshell

Figure 2-9 — HSA 402 AAP cable routing, rear view

Bezels

The HSA ships with RJ-45/RJ-11 connector bezel plug-ins in a

variety of colors and a black, blank bezel.
To change to a different color connector bezel,

or if a connector is not needed or desired,

replace the connector bezel plug-in on the front

panel with a bezel of a different color or a blank

plug-in.  See “Replacing the Bezels” in chapter 3.

If no connector is desired, snap the

interior RJ-45 connector onto the rear of

the blank bezel plug-in to hold it

conveniently out of the way.  Retain the

removed connector bezel plug-in for

any possible later use.

Bezel

2-13

2-12