IPL Pro Series • Hardware Features and Installation
10
Network Communication Setup
Network setup is essential prior to configuration. Use the flowchart as a guide to setting up
the control processor for network use.
Open the Toolbelt software from within
Global Configurator (GC Professional or GC Plus mode)
or as the stand-alone application.
Start Device Discovery.
Toolbelt displays a list of all Extron control devices
connected to the network.
Using the MAC address, locate the desired device
in the list and select it.
Network Communication Setup
Connect the control processor
and PC to the same network.
Apply power to all devices.
Use the Set IP feature in Toolbelt
or
use the Toolbelt
Manage
>
Network Settings
tab
feature to enter the IP address, subnet address,
and gateway, then configure other network settings
as needed.
Figure 5.
Network Setup
Rev. D, 03/2017: Updated network setup
flowchart to reflect the latest Toolbelt info.
Rev. E, 07/2018: updated wording to add the
Toolbelt Manage feature.
Summary of Contents for IPL Pro CR88
Page 6: ......
