Figure 8.
Confirm Amplifier Output Mode Selection Dialog Box
4.
Click
Yes
to confirm the amplifier output mode selection and apply it to the amplifier.
ATTENTION:
•
Verify output connector wiring and speaker configuration to avoid damage to the speakers and/or amplifier
malfunction prior to clicking
Yes
.
•
Vérifiez le câblage du connecteur de sortie et la configuration du haut-parleur pour éviter les dommages aux haut-
parleurs et/ou au dysfonctionnement de l’amplificateur avant de cliquer sur
Oui
.
Downloading and Installing Dante Controller
1.
From
www.extron.com
, hover over the
Download
tab at the top of the page.
2.
From the
Featured Software
list, select
Dante Controller
. The
Dante Controller
product page opens.
3.
Click the blue
Download
button.
4.
Select
Run
to run the Dante Controller installer or select
Save
to save the install file to run at a later time.
If you choose to run the file, follow all prompts. If you saved the file, click the saved file to begin installation when ready.
NOTE:
The installed Dante Controller program files are saved in
:
C:\Program Files (x86)\Audinate\Dante Controller\DanteController.exe
.
Configure Dante Device Settings
Dante settings in the NetPA U 2002 SB can be configured from DSP Configurator. The device can be named in the
Dante
Device Settings
, which assists with identifying a specific device in the Dante Controller software when there are multiple
devices on the Dante network.
ATTENTION:
•
It is crucial that a Dante device be named before audio subscriptions with other devices are established. Existing
subscriptions are removed when a unit is renamed.
•
Il est crucial qu’un appareil Dante soit nommé avant la création d’abonnements audio avec d’autres appareils. Les
abonnements existants sont supprimés lorsqu’une unité est renommée.
To configure Dante device settings:
1.
Open DSP Configurator and connect live to the NetPA U 2002 SB.
2.
Select
Tools
>
Device
Settings
.
The
Device Settings
dialog box opens.
3.
From the tabs at the top of the
Device
Settings
dialog box, select
Dante Device
.
4.
In the
Device
Name
field, give the NetPA U 2002 SB a name (recommended to be device model and location) so that it can
be easily identified in Dante Controller. No spaces are allowed in the name.
5.
Dante device network settings can also be configured in this dialog box. Use the radio buttons and text fields to choose
DHCP
(recommended) or
Static
IP
and enter a static IP address configuration.
6.
Click
Apply
.
7.
Click
OK
to confirm changes and close the
Device Settings
dialog box.
7
