3
Getting Started — Prepare the Retractors
The Retractor SM modules are delivered ready to mount vertically. No further modifications are required. If the Share button is not
seated fully against the cable release assembly, confirm proper tension adjustment using the instructions in the
Retractor SM User
Guide
.
To mount a Retractor horizontally or at an angle:
Install the two enclosure screws
removed in step 1 (one on each side)
in the angular mounting location.
3
Rotate the cable stop to
the horizontal position
for installation.
4
Mounting Location
For angular mounting, move the
cable stop assembly upward until
the angular mounting hole is visible.
Go to
3
.
2
Angular Mounting Hole
Remove two enclosure screws
(one on each side) from this position
for horizontal and angular mounting.
Cable Stop Assembly
1
Share Button
Screws (one on each side)
To mount the Retractor at an angled position for increased under-table clearance:
Install the two enclosure screws
removed in step 1 (one on each side)
in the angular mounting location.
3
Rotate the cable stop to
the horizontal position
for installation.
4
Mounting Location
For angular mounting, move the
cable stop assembly upward until
the angular mounting hole is visible.
Go to
3
.
2
Angular Mounting Hole
Remove two enclosure screws
(one on each side) from this position
for horizontal and angular mounting.
Cable Stop Assembly
1
Share Button
Screws (one on each side)
Getting Started — Prepare the Enclosure
By now, you should be certain the Retractor SM modules have adequate under‑table clearance for installation and that proper
legroom is provided to avoid accidental contact with the system. You should have the required accessories for mounting the
retraction system and to configure the enclosure (see
Required Tools and Additional Accessories
on page 1).
Horizontal
Bracket
Top View
U
S
B
C
H
A
R
G
E
R
NOTE:
For horizontal mounting instructions see
the
Retractor SM User Guide
and the
Retractor
SM Horizontal Bracket Installation Guide
.
DANGER:
• Disconnect the power from the Cable Cubby enclosure before
beginning a Retractor system installation.
• Débranchez l’alimentation du boîtier Cable Cubby avant de
commencer l’installation d’un système de Rétracteur.
