ShareLink 200 • Operation Using a Computer
9
Setting Up the ShareLink 200 Software
Downloading and Installing the ShareLink 200 Software
The ShareLink 200 software can be downloaded from the embedded web pages or from
the Extron website. Follow the instructions below for your preferred download method.
Downloading the software from the embedded Web pages
1.
Ensure that your computer is connected to the ShareLink 200 device, either through
Wi-Fi or through a physical network connection. The computer and the ShareLink 200
must be on the same network.
2.
Launch your internet browser and enter the IP address of the ShareLink 200 into the
browser.
NOTE:
The IP address is shown on the standby screen (see
,
4
on page 5).
The ShareLink 200 landing page should appear on the browser.
3.
Click
Windows
or
Mac
(depending on your operating system) to launch the software
installer on your computer.
4.
Follow the instructions on the web browser to run the the executable ShareLink 200
Software installer file.
5.
Follow the steps on the installation wizard to install the software.
Downloading the Software from the Extron Website
1.
Go to
and click the
Download
tab at the top of the page (figure 7,
1
).
2
2
1
1
Figure 7.
Download Page on the Extron Website
2.
Click
Software
on the left menu (
2
).
3.
Scroll down to the alphabetical menu and click the letter
S
.
4.
Scroll down to the software names and look for ShareLink 200. Click
Download
in the
ShareLink 200 section.
5.
On the next screen (Download Center), enter the requested information and click the
download button.
6.
When download is complete, open the executable ShareLink 200 Software installer file
and follow the steps on the installation wizard to install the software.
Hyde 116 is: 158.136.28.9
