ShareLink Pro 500 • Installation
6
HDMI Connection
To secure the HDMI cable to the HDMI input connector, use an Extron LockIt Cable Lacing
Bracket and a tie wrap.
3
1
2
3
4
5
Figure 4.
Installing the LockIt Cable Lacing Bracket
1.
Plug the HDMI cable into the panel connection (see figure 4,
1
).
2.
Loosen the HDMI connection mounting screw from the panel (
2
) enough to allow the
LockIt to be placed over it. The screw does not have to be removed.
3.
Place the LockIt on the screw and against the HDMI connector (
3
), and then tighten
the screw to secure the bracket.
4.
Loosely place the included tie wrap around the HDMI connector and the LockIt (
4
).
5.
While holding the connector securely against the cable lacing bracket, use pliers or
similar tools to tighten the tie wrap, then remove any excess length (
5
).
ATTENTION:
•
Connect and pull the tie wraps until they are secure. Do not overtighten.
•
Connectez et tirez les serre-câbles jusqu’à ce qu’ils soient sécurisés. Ne pas
trop serrer.
Summary of Contents for ShareLink Pro 500
Page 2: ......
