ShareLink Pro 500 • Installation
5
F
LAN port
—
Use an Ethernet cable to connect a network switch, hub, router, or PC to
this RJ-45 port. This port can also be used for Power over Ethernet (PoE+).
NOTE:
Default IP settings
:
•
IP address: 192.168.254.254
•
Gateway IP address: 0.0.0.0
•
Subnet mask: 255.255.255.0
•
DNS address: 0.0.0.0
•
DHCP: Off
•
Link speed and duplex level: autodetected
LED indicators
:
•
Left LED (amber) indicates link speed:
1 blink per second
: 10 Mbps
2 blinks per second
: 100 Mbps
3 blinks per second
: 1 Gpbs
•
Right LED (green) indicates a link is active.
Power Notifications
ATTENTION:
•
If not provided with a power supply, this product is intended to be supplied by a
UL Listed power source marked “Class 2” or “LPS” and rated output 12Vdc,
minimum 2.0 A, or 56 Vdc (PoE+), minimum 0.8 A.
•
Si le produit n’est pas fourni avec une source d’alimentation, il doit être alimenté par
une source d’alimentation certifiée UL de classe 2 ou LPS, avec une tension nominale
12 Vcc, 2,0 A minimum, ou 56 Vcc (PoE+), 0,8 A minimum.
•
Unless otherwise stated, the AC/DC adapters are not suitable for use in air handling
spaces or in wall cavities.
•
Sauf mention contraire, les adaptateurs AC/DC ne sont pas appropriés pour une
utilisation dans les espaces d’aération ou dans les cavités murales.
•
The installation must always be in accordance with the applicable provisions of
National Electrical Code ANSI/NFPA 70, article 725 and the Canadian Electrical Code
part 1, section 16. The power supply shall not be permanently fixed to a building
structure or similar structure.
•
Cette installation doit toujours être en accord avec les mesures qui s’applique au
National Electrical Code ANSI/NFPA 70, article 725, et au Canadian Electrical Code,
partie 1, section 16. La source d’alimentation ne devra pas être fixée de façon
permanente à une structure de bâtiment ou à une structure similaire.
•
Power over Ethernet (PoE) is intended for indoor use only. It is to be connected only
to networks or circuits that are not routed to the outside plant or building.
•
L’alimentation via Ethernet (PoE) est destinée à une utilisation en intérieur
uniquement. Elle doit être connectée seulement à des réseaux ou des circuits qui ne
sont pas routés au réseau ou au bâtiment extérieur.
Summary of Contents for ShareLink Pro 500
Page 2: ......