ShareLink Pro 500 • Installation
7
Reset Modes
The rear panel
Reset
button can activate four different reset modes (see the table below for a summary
of each reset mode and LED state).
NOTE:
Review the reset modes carefully. Some reset modes delete all user-loaded content.
Reset Mode Summary
Mode
Activation
Result
Factory Firmware Reset
(mode 1)
Resets the firmware to the
factory version temporarily if an
incompatibility issue arises with
the current firmware.
Hold down the recessed
Reset
button
while applying power to the device.
NOTE:
After this reset, update the
device with the latest firmware
version. Do not operate the
device with the firmware version
that results from this reset.
The device reverts to the factory default
firmware for a single power cycle. All user files
and settings are maintained.
NOTE:
If this reset was made by mistake
or is no longer desired, cycle power
to the device again to restore the
firmware version running prior to the
reset.
Reset to Factory Defaults
(mode 3)
Resets all device settings to
default values but retains
user-loaded files and IP settings.
NOTE:
This reset is the
equivalent of SIS command
ZXXX
)
Hold down the
Reset
button (for about
3 seconds) until the Reset LED blinks
once. Then, press the
Reset
button
again momentarily (<1 second).
The device reverts all settings to the default
values except:
•
IP related settings
•
User-loaded files and configurations
NOTE:
•
This mode does not affect
passwords.
•
The Reset LED blinks four times in
quick succession during the reset,
then remains on.
IP Settings Reset
(mode 4)
Resets the IP settings back to
factory defaults.
Hold down the
Reset
button for about
6 seconds until the Reset LED blinks
twice (once at 3 seconds, then twice at
6 seconds). Then, within one second,
press the
Reset
button again momen-
tarily (for <1 second).
NOTE:
Nothing happens if the
button is not pressed within one
second.
The device reverts IP settings to the default
values.
•
ARP capability is enabled.
•
IP address, subnet mask, gateway address,
and port mapping reset to the default value.
•
DHCP is disabled.
•
Events are disabled.
NOTE:
The Reset LED blinks four times
in quick succession during the reset,
then remains on.
Reset to Factory Defaults
(mode 5)
Resets the device to default
configuration.
NOTE:
This reset is the
equivalent of SIS command
ZQQQ
)
Hold down the
Reset
button for about
9 seconds until the Reset LED blinks
three times (once at 3 seconds, twice
at 6 seconds, and thrice at 9 seconds).
Then, within one second, press the
Reset
button again momentarily (for
<1 second).
NOTE:
Nothing happens if the
button is not pressed within one
second.
The device reverts user settings to the factory
default values (firmware excluded).
•
All user modifiable configuration is reset
to default values, including IP settings and
real-time adjustments.
•
All user loaded files are deleted.
NOTE:
•
Admin password resets to
extron
.
•
The Reset LED blinks four times in
quick succession during the reset,
then remains on.
Summary of Contents for ShareLink Pro 500
Page 2: ......
