ShareLink Pro 500 • Installation
8
Front Panel Features and Cabling
ShareLink Pro 500
HD WIN
STANDBY
SCREEN
DECODER
HD PASS
HDMI
DECODER
SIGNAL
HDCP
CONFIG
OUTPUT
INPUT
HDMI
WINDOW
HDMI
PASS-THROUGH
USB
A
A
B
B
D
D
E
E
C
C
F
F
Figure 5.
Front Panel
A
Power LED indicator
— Lights green when the unit is powered on.
B
Config USB port
(future use)
C
HDMI input selection buttons
— Use these buttons to select between HDMI window
mode and pass-through mode. These modes determine how the HDMI input is
presented on the output (see below for details).
NOTE:
Selection of one mode deselects the other mode.
•
HDMI Window
button – Activates HDMI window mode, which displays the HDMI
input source in addition to or alongside any content currently being shared by client
devices.
NOTE:
Maximum output resolution for this mode is 1080p @ 60 Hz.
•
HDMI Pass-Through
button – Activates HDMI pass-through mode, which routes
the HDMI input signal directly to the HDMI output unaltered. In this mode, neither
the status bar nor decoder input streams are shown on the output.
NOTE:
Maximum output resolution for this mode is 4K @ 60 Hz.
D
Input LED indicators
:
•
HDMI Signal LED
– Lights green when an HDMI signal is detected.
•
Decoder Signal LED
– Lights green when one stream is detected. Flashes green
when more than one stream is detected at the same time.
•
HDCP LED
– Lights green when the source signal is encrypted. Turns off when
input signal is not encrypted or when HDCP authorization is disabled.
E
Output LED indicators
— These LEDs light green when the source signals are present
and active on the output.
•
HD Win
– Lights green when the HDMI source is active on the output in HDMI
window mode. Lights amber if HDMI pass-through mode is activated after originally
being in window mode.
•
Decoder
– Lights green when at least one stream is active on the output. Lights
amber if HDMI pass-through mode is activated after at least one stream was active
on the output.
•
Standby Screen
– Lights green when the standby screen is active on the output.
Lights amber if HDMI pass-through mode is activated while the ShareLink Pro
output displays the standby screen.
NOTE:
The standby screen images are displayed only when HDMI and decoder
sources are
not
active.
•
HD Pass
– Lights green when the HDMI source is active on the output in pass-
through mode.
F
USB port
(future use)
Summary of Contents for ShareLink Pro 500
Page 2: ......
