USB port
on page 8) — Compatible with USB 2.0. The TLP Pro 525T,
TLP Pro 725T, and TLP Pro 1025T have a plastic cover that must be removed for access to
the USB port.
Speaker
(TLP Pro 525M, 725M, and 1025M only) —
P
rovides audible feedback for the user.
The TLP Pro 525M and 725M have a single speaker. The TLP Pro 1025M has two (dual
mono) speakers.
Slot for mounting plate
(TLP Pro 525M, 725M, and 1025M only) — The tongue at the
bottom of the mounting plate fits into this slot, for wall mounting (see
.
Mounting screw
(TLP Pro 525M, 725M, and 1025M only) — T
ightens against the tongue
of the mounting plate to secure the touchpanel (see
Mounting the TLP Pro 525M, 725M, and
).
Rear status light
— The TLP Pro 525M does not have any rear panel status lights. The
TLP Pro 725M has six LEDs (three on each side of the rear panel). The TLP Pro 1025M has
a single LED strip on each side. The TLP Pro 525T, TLP Pro 725T, and TLP Pro 1025T have
a single LED (top center of the rear panel).
The lights can blink or remain steadily lit and they can light red or green. The lights can be
configured (using Global Configurator) or programmed (using Global Scripter) to provide
feedback information about the system using these variables. Different combinations, for
example a red LED lit steadily or a green LED that is blinking, can provide indications about
the system. For information about setting up these LEDs, see the
Global Configurator Help
File
or the
Global Scripter Help File
.
The rear panel status lights of the TLP Pro 725M and the TLP Pro 1025M can be disabled,
using the
(see page 14).
Cable guide
(TLP Pro 525T, 725T, and 1025T only) — The Ethernet cable is inserted
through this hole at the back of the base (also see
C
, on the following page).
USB port
Speaker
Slot for mounting plate
Mounting screw
Rear status light
Cable guide
TLP Pro 525, 725, and 1025 Series Touchpanels • Panel Features
11
