Connect a straight-through Ethernet cable from the power injector to a switch or router
(see
1
, on page 9). This cable carries network information from the switch or
router to the power supply. A second straight-through cable carries the network information
and 48 VDC from the power injector to the touchpanel (
). Connect the IEC power cord to
a convenient 100 VAC to 240 VAC, 50-60 Hz power source (
).
ATTENTION:
•
Do not power on the touchpanels or control processors until you have read the
about Power over Ethernet (PoE) power supplies (see page 10).
•
Ne branchez pas les écrans tactiles ou les processeurs de contrôle avant d’avoir lu
la
sur les sources d’alimentation via Ethernet (PoE) (voir page 10).
Speaker
on the previous page) —
A single speaker
provides audible feedback
for the user.
Speaker
TLP Pro 525, 725, and 1025 Series Touchpanels • Panel Features
13
