TP Receivers • Installation and Operation
TP Receivers • Installation and Operation
Installation and Operation, cont’d
2-12
2
Composite video transmission connector —
Attach one end of
a TP cable to this RJ-45 female connector. Attach the other end
to an Extron TP composite video transmitter. See
Termination of
TP cable
on page 2-15 for pin assignments.
Output cabling
Computer video
The TP R BNC A, TP R BNC AV and TP R 15HD A receive and
output RGB video. These receivers can also receive component
video, S-video, or composite video and output them on the R,
G, and B signal lines.
Reception of component video, S-video, or composite video
requires that an internal jumper (TP R BNC AV and TP R BNC)
or external DIP switch (TP R 15HD A) be repositioned. See
Video jumpers
or
Video DIP switch
in this chapter.
3
RGB Output BNCs (TP R BNC A and TP R BNC AV)
—
Connect the desired video output device to the rear panel
output BNCs:
For RGBHV video, use the R, G, B, H/HV, and V BNCs.
R
G
B
H/HV
V
For RGBS video, use the R, G, B, and H/HV BNCs.
R
G
B
H/HV
V
For RGsB or component video, use the R (R-Y), G (Y), and B
(B-Y) BNCs.
R
G
B
H/HV
V
For S-video, use the R (C-chroma) and G (Y-luma) BNCs.
R
G
B
H/HV
V
For composite video, use the R, G, and/or B BNC.
R
-or-
-or-
G
B
H/HV
V
The H/HV and V BNCs only output sync, not video,
signals.
4
RGB Output 15HD (TP R 15HD A)
—
Connect the desired video output device to
the rear panel output 15HD connector.
At the TP transmitter, input only
sync signals, no video signals, on
the sync pins, 13 and 14.
For component video, use the R (R-Y) and R return pins
(pins 1 and 6), G (Y) and G return pins (pins 2 and 7),
and B (B-Y) and B return pins (pins 3 and 8).
For S-video, use the R, R return (C-chroma), G, and G
return (Y-luma) pins.
For composite video, use the G pin and the associated
return pin. For additional genlocked video signals, use
the R, B, and associated return pins.
5
DIP switches
SOG switch
— Set this rear panel switch up for
RGsB video and down for RGBHV or RGBS
video.
C Sync switch —
Set this rear panel switch up for
RGBS video and down for RGBHV or RGsB
video.
C video switch (TP R 15HD A only) —
Configures the transmitter for RGB or
component/S-video/composite video. See
Video DIP switch
in this chapter.
Set all three DIP switches down for
RGBHV video.
N/C (TP R 15HD A only) —
No connection.
Composite video
The TP R BNC AV and the TP R AV receive and output
composite video.
6
Video connector
— Connect a composite video device to this
rear panel BNC connector. Digital audio can also be connected
to this connector.
2-13
C SYNC
SOG
C VIDEO
N/C
ON
SOG
C SYNC
5
1
15
11
6
10
Female
