TP Receivers • Installation and Operation
Installation and Operation, cont’d
2-10
All models except the TP R 15HD A can be mounted through a
table or podium using an Extron Through-Desk Mounting Kit
for 1/4 or 1/2 Rack Width Products (part #
70-077-02
). Furniture
mount the receiver as follows:
1
.
Attach the mounting brackets to the receiver with the
machine screws provided (figure 2-5).
Extron
TP R BNC A
Extron
TP R BNC A
Extron
TP R 15HDA
RGB IN
PUT
RGB
OUTPUT
R
G
B
H/H
V
V
A
AUDI
O
L
R
B
SO
G
C SYNC
PO
WE
R
15V .
5A
DC
L
R
RG
B I
NP
UT
RG
B O
UT
PU
T
R
G
B
H/H
V
V
A
AU
DIO
L
R
B
SOG
C SY
NC
PO
WE
R
15V
.5
A D
C
L
R
Through-desk
Mounted
Under-desk
Mounted
Under-desk
Mounted
TP R 15HD
A
RGB
PEA
KIN
G
LEV
EL
Figure 2-5 — Under-desk or through-desk mounting
2
.
For through-surface mounting (all except TP R 15HD A)
,
cut the proper sized hole in the mounting surface.
3
.
Hold the receiver with the attached brackets against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
4
.
Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
5
.
For through-surface mounting (all except TP R 15HD A)
,
insert four #8 wood screws through the bracket and into
the four pilot holes. Tighten all four screws to secure the
receiver in place.
6
.
For under-surface mounting
, insert #8 wood screws into
the four pilot holes. Tighten each screw into the mounting
surface until slightly less than 1/4" of the screw protrudes.
