•
IP
address
— follow steps 1 through 4 of the Control section on the previous page.
•
Subnet
mask
— follow steps 1 through 4 of the Control section.
•
Gateway
— follow steps 1 through 4 of the Control section.
•
MTU
— use either rotary encoder to adjust the
MTU
value (
150
-
9000
).
ATTENTION:
•
The
MTU
setting adjusts the data payload in each network packet. The default
setting of
1500
does not normally require adjustment.
•
Le paramètre
MTU
ajuste la charge utile de données dans chaque paquet
réseau. Le paramètre par défaut
1500
ne nécessite généralement aucun
ajustement.
•
All devices in the network should be set to the same value. Setting different
values for different devices may cause failures in the VN-Matrix streaming
network.
•
Tous les appareils du réseau doivent avoir la même valeur. Un paramétrage
avec des valeurs différentes sur plusieurs appareils peut entraîner des
défaillances dans le réseau de streaming VN-Matrix.
•
Mode
— use either rotary encoder to toggle between
100
Mbps
and
1000
Mbps
network
modes.
•
DHCP
— use either rotary encoder to toggle between
enable
and
disable
.
System Control
The
System
Control
editing screen allows you to configure the
IP
address
and
port
number
of the system controller.
Input Submenu
The
Input
submenu allows you to select the input source, enable or disable the loop-
through video signal, and enable or disable the power save feature for the loop-through
signal.
Input
MENU
NEXT
Select auto
NEXT
Select:
auto
HDMI
VGA
input
Select:
Enabled
Disabled
NEXT
Loop through
[Enabled]
Select:
Enabled
Disabled
NEXT
Power save
[Enabled]
NEXT
Figure 79.
VNE 250 Encoder Input Submenu
VNM 250 • Front Panel Menu Configuration
97
Summary of Contents for VN-Matrix 250 Series
Page 6: ......
