•
7
— this option sets the DHCP IP range and is only available when DHCP is
enabled (option
6
). Enter the DHCP pool address range in the following format:
xxx.xxx.xxx.xxx
<
space
>
xxx.xxx.xxx.xxx
where the lower IP address value and the upper IP address value are separated by
a single space.
•
9
— this option saves all changes, closes the controller and DHCP config page,
and automatically reboots the device in the config login.
7.
Select
9
followed by <
Enter
>.
The controller and DHCP configuration settings page closes and the device
automatically reboots to the config login screen. The changes that were made in steps
4 through 6 are implemented.
Setting a VNM 250 Device as the System Controller
All Matrix systems require one device that acts as the system controller. For small systems
(ten devices or fewer), this can be either a VNE 250 or VND 250. For larger systems, a
VN-Matrix Enterprise Controller must be used.
The VNM 250 device that is chosen as the system controller must use static IP address
settings.
Extron recommends using
Low Level Device Configuration
device as the system controller.
Configuring the System Controller with a Static IP Address
To configure the system controller with a static IP address:
1.
of each device (see page 25) and ensure that the
Streaming Network port
IP Prov mode
(option 11) is set to static.
2.
Set the IP address (option 12), netmask (option 13), and gateway (option 14) for the
streaming network (LAN 2).
3.
Set the controller IP address (option 8) to the same address as the streaming port.
4.
Use option 9 to exit from the configuration menu.
Configuring Other VNM 250 Devices with a Static IP Address
To configure the system with static IP addresses for all devices:
1.
(see page 25) and ensure that the Streaming Network
port
IP Prov mode
(option 11) is set to static.
2.
Set the IP address (option 12), netmask (option 13), and gateway (option 14) for the
streaming network (LAN 2).
3.
Set the controller IP address (option 8).
NOTES:
•
Every device must have a unique Streaming network port (LAN 2) IP address
(option 12).
•
Every device in the system must have the same controller IP address
(option 8) and this must be the same as the streaming network port (LAN 2)
IP address on the device selected to be system controller.
4.
Use option 9 to exit from the configuration menu.
5.
Use option 9 again to exit from the controller and DHCP menu.
6.
Repeat steps 1 through 5 to configure all other VNM 250 devices in the system.
VNM 250 • Low Level Device Configuration
28
Summary of Contents for VN-Matrix 250 Series
Page 6: ......
