Audio Connections
Audio loop-through (VNE 250)
—
connect a 3.5 mm TRS jack to this
socket for unbalanced buffered output
from the audio input source (see
M
on page 13).
Analog program audio input
(VNE 250)
— connect balanced or
unbalanced, mono or stereo audio
to this 5-pole, 3.5 mm captive screw
receptacle (see
N
).
Return audio input (VND 250)
—
allows bidirectional communication,
using a reverse audio signal sent from
a decoder to the associated encoder. Connect balanced or unbalanced, mono or stereo
audio input to this 5-pole, 3.5 mm captive screw connector (see
,
O
).
Return audio output (VNE 250)
— allows bidirectional communication by sending a
reverse audio signal from an associated decoder, to be played by the encoder. Connect the
audio output from this 5-pole captive screw connector to an amplifier or powered speakers
(see
,
P
).
Analog program audio output (VND 250)
— connect the audio output from this 5-pole
captive screw connector to an amplifier or powered speakers (see
,
Q
).
Reset
Reset button
— is used to reboot the operating system. To activate this recessed button,
insert the blade of a small screwdriver or a similar device into the hole and press the button
(see
,
J
,
J
).
NOTE:
The reset button simply reboots the system. It does not alter any settings.
To reset IP addresses, use the Reset option on the front panel menu (see
LOOP THRU
LOOP
THRU
RGB
AUDIO
L
R
RETURN AUDIO
L
R
INPUT 2
OUTPUT
VNE 250
AUDIO
L
R
RETURN AUDIO
L
R
INPU
T
OUTPUT
VND 250
VNM 250 • Rear Panel and Connections
22
Summary of Contents for VN-Matrix 250 Series
Page 6: ......
