Installation, cont’d
WPB 103B and WPB 107B Wall Plates • Installation
If a suitable wall box is already installed follow steps
5 through 7. To install a wall box, follow all the steps below.
1.
If a wall box is not available to use for a template, use the
template on page 8. If installing directly into furniture,
cut out the center portion of the template.
The template is not to scale, and is for reference only.
Full size templates are available online at
www. extron.com.
2.
Place the template (or the wall box) against the
installation surface, and mark the guidelines for the
opening on the wall or furniture.
3.
Cut out the material from the marked area.
4.
Check the opening size by inserting the wall box into the
opening. The box or the wall plate’s rear connectors
should fit easily into the opening. Enlarge or smooth the
edges of the opening if needed.
5.
Feed cables for the output devices through the opening
and through the wall box punch-out holes, securing them
with cable clamps to provide strain relief.
6.
Trim back and/or insulate exposed cable shields with
heat shrink to reduce the chance of short circuits.
To prevent short circuits, the outer foil shield can
be cut back to the point where the cable exits the
cable clamp. Both braided and foil shields should
be connected to an equipment ground at the other
end of the cable.
7.
Connect the output device cables to the rear of the wall
plate (see “Rear Panel Connectors” on page 3 for
method).
8.
Connect input devices (see “Front Panel Connection
Points” on page 4) and test the wall plate. Make any
output device cabling adjustments before final
installation into the wall box or furniture as the cables
will be inaccessible afterwards.
2
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de
