Extronics Limited
1 Dalton Way, Midpoint 18, Middlewich, Cheshire, UK. CW10 0HU
Tel:
+44 (0) 845 277 5000
Fax:
+44 (0)845 277 4000
E-mail:
info@extronics.com
Web:
12
5
Step by step guide to installation and operation
5.1
General connection of handheld scanner
Do not replace the battery in hazardous areas.
Incorrect handling may result in the termination of the
operating permit.
The battery compartment is located at the bottom of the
Bluetooth handheld scanner. Loosen the screw to remove the
lid.
Open the battery compartment.
After the screw has been loosened, the removal of
the lid requires a certain amount of force.
An iSCAN2X3BATT is required to operate the Bluetooth
handheld scanner.
Use only this battery for the Bluetooth scanner.
Before placing the battery inside the scanner, remove its
protective cap.
Insert the battery into the battery compartment of the
scanner. The end of the removal strap must protrude from the
opening.
If the battery has been correctly inserted and
connected to the contacts, this will be indicated by
an acoustic and a visible signal.
Close the compartment.
Check that the screw has been tightened properly.
