USB-MUXDIAG-II – User guide
16/05/2012
00283735-v1
22
Document confidentiel appartenant à Annecy Electronique S.A.S.
Ne peut être diffusé, copié intégralement ou en partie sans autorisation expresse préalable
6.1.9.
Installation
6.1.10.
Installation goal
The new driver installation goal is to improve the performances of applications working with
EXXOTEST® card and interfaces through USB and PCI buses.
6.1.11.
Warning
To support this update, any application which is not provided by Annecy Electronique and
which works with Exxotest card or interface (proprietary application) must realize a
“dynamic load” of the software library or being recompiled with this new library.
You are strongly advised to check with people who develop these
applications before performing this driver update.
6.1.12.
Driver installation and applications update
The driver update will be performed accordingly to following steps:
-
Either from the KIT CD MUX (if 2012 version or higher) that came with your
EXXOTEST® card or interface, or from a downloaded version from the
www.exxotest.com
downloads webpage, execute the installation file :
«
Exxotest_MUX_driver_kit_2.x.x »
-
EXXOTEST® applications update:
o
MUXTRACE EXPERT – 4.86 version or higher
o
DLC / DLC Light – 1.19 version or higher
o
MUXSERVER – 1.25 version or higher
o
USBMAJ – 2.13 version or higher
o
DCP – 1.14 version or higher
-
Update of the software libraries (MUXDLL.dll) associated to your proprietary (non
EXXOTEST®) working with EXXOTEST® card or interfaces.
Attention: Check with the supplier or service responsible for distributing these
applications to the good compatibility of these applications before installing the
EXXOTEST® Driver Kit and utilities v2.xx
-
Update of the firmware of your EXXOTEST® interface (USB only) using the USBMAJ
utility version 2.13 or higher.
