@ Eye Trax, Inc All Rights Reserved
Page 27 of 27
Camera Is Sending Too Many Pictures With No Motion Sensor Trigger
Step 1.
Send picture acquisition settings to the camera with Motion Sensor set to “OFF”
by selecting the “Settings” icon on the User Interface. Allow camera to send all pictures in
queue to the User Interface. Once 30 minutes has passed, send desired Motion Sensor
picture acquisition rate back to camera.
(see User Interface page #12 for instructions)
Step 2.
Verify a device that may be emitting a radio frequency is not triggering the motion
sensor including: radios, cellular phones, wireless networks, etc.
Step 3.
Power cycle camera by turning it “OFF” for 60 seconds and then back “ON.”
Motion Detector Is Not Triggering:
Step 1.
Send picture acquisition settings to the camera with Motion Sensor set to “OFF”
by selecting the “Settings” icon on the User Interface.
(see User Interface page #12 for
instructions)
Step 2.
Verify the red light is bright red on the motion sensor while in active “waiting”
mode and dim when “triggered”. There is a slight audible click when the sensor is
triggered and resets.
Step 3.
Verify the motion sensor is not obstructed in any way.
Step 4.
Power cycle camera by turning it “OFF” for 60 seconds and then back “ON.”