EZTouchPLC
53 / 64
Copy file(s) on USB Drive
Copy file(s) created by the editor on the root directory of a USB flash disk.
(Please note files copied in a location other than root directory would not be
read by the panel.) All files are saved automatically with .hmi extension. Files
without this extension will not be read.
Programming the panel using USB Drive
To program an
EZTouchPLC
from USB Drive, insert the USB flash directly into the
EZTouch
I/O
USB port. The panel would display a list of files available in the
root directory (with .hmi extension). An example is shown below:
Select the required project using the Up-D o w n arro w s an d press ““ccept.” I f th e
panel is
not compatible
with the project selected, an Error message saying
“Wrong panel Type” is displayed .
The selected project is then automatically
loaded into the
EZTouchPLC
.
Summary of Contents for EZTouch I/O Flex
