EZTouchPLC
38 / 64
Transfer a Project
After a project is complete, the next step is to transfer the project to the
EZTouch I/O Flex
C unit. When editing projects online, programming
information is
automatically sent to the unit once the project is saved. When
editing in an off-line mode, the project information will need to be transferred.
To transfer the
project through the serial connection or Ethernet port, follow the
steps outlined
below:
From the Project drop down menu, select
File
>
Transfer to Panel
. A dialog box
similar to the one below will appear.
Transferring via USB programming cable:
1.
Please connect your USB programming cable to the panel and your computer
prior to launching the EZ Series Editor Software.
2.
Under
Transfer To
, select
Both
in order to transfer both the created Panel
program and the PLC ladder logic project.
3.
Select
Serial (COM xx)
as method of transfer under PC to Panel Connection.
And then click
Start
.
Transferring via Ethernet:
1.
Select Ethernet as PC to Panel Connection.
Note
: Click the
Specify IP/Port
button in order to make adjustments to the IP
Address or Port.
2.
Under
Transfer To
, select
Both
in order to transfer the created Panel program
and the PLC ladder logic project.
3.
Then click
Start
.
When finished, a Transfer Completed message will be displayed. Click OK to
continue and the project is now transferred.
Summary of Contents for EZTouch I/O Flex
