WARNING:
To reduce the risk of injury, user must read and understand
the operator’s manual for their pressure washer before us-
ing this accessory. To reduce the risk of injury or property
damage, spray the pressure stream in a safe direction
to ensure proper connection of all accessories before
starting any cleaning project. Fits most pressure wash-
ers. Ensure compatibility and proper fit before using this
accessory. Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Risk of fluid injec-
tions; do not point at people, pets, electrical devices or
the unit itself. Turn off the pressure washer before chang-
ing or adjusting accessories. For cold water use only.
Save these instructions. Refer to them frequently and use
them to instruct other users. If you loan someone this tool,
loan them these instructions also. Do not use this acces-
sory if it appears damaged or if any parts are missing.
WARNING:
To reduce the risk of injection or injury, only use the sur-
face cleaner on flat, horizontal surfaces. Never lift the
surface cleaner from the cleaning surface while operating
the pressure washer.
n
Always test in an inconspicuous area first.
n
Do not operate in an area for more than 2 seconds or
damage may occur.
PRODUCT SPECIFICATIONS
See Figures 1 and 4.
Connections .............................1/4 in. Quick Connect Plug
Deck Width ................................................................. 12 in.
Maximum Pressure ....................................... up to 1800 psi
Maximum Water Flow ................................................2 gpm
Maximum Water Temperature ....................................104°F
RAISING AND LOWERING THE SPRAY BAR
See Figure 1.
Adjust the height of the spray bar by moving the sliding latch
away from the surface cleaner and pulling up or pushing
down on the height adjustment handle. Release the sliding
latch to secure in place.
n
Raise the spray bar assembly for delicate surfaces like
wood decks.
n
Lower the spray bar assembly for hard surfaces like
concrete, stone, brick, etc.
INSTALLING THE SURFACE CLEANER ON THE
SPRAY WAND
See Figure 2.
Insert the surface cleaner inlet plug into the spray wand quick
connect coupler and secure.
USING THE SURFACE CLEANER
See Figure 3.
n
Once the surface cleaner is installed, connect the hose
to the pressure washer as described in your pressure
washer manual.
n
Start the pressure washer as described in your pressure
washer manual.
n
Walk slowly behind the surface cleaner, cleaning as you go.
Fig. 1
Fig. 2
12 in. Surface Cleaner Attachment
AP31063
HEIGHT
ADJUSTMENT
HANDLE
CARRY
HANDLE
QUICK
CONNECT
COUPLER
SLIDING
LATCH
SURFACE
CLEANER
INLET PLUG
