17
Use ▲or ▼ to select option Display progress status
Final result
3.3 Capacity Check+Format
It will format the target devices to the file format according to the system Setup (please refer
to 4.7 Set Format Type), then sort out target devices based on the capacity threshold
(please refer to 4.8 Set Capacity Threshold). Duplicator will display the target device which is
not in the capacity range and its red LED will flash. Press
▲▼ button to switch between the
target devices with smaller capacity to check the data status. The ones without capacity
issue will not be displayed to expedite the capacity check process. If Format and or Capacity
Check is failed, the red LED will stay solid on.
3.4 Measure Speed
This option allows to measure the actual Read and Write speed of the target device. This
option will NOT alter or erase existing data on the target device.
Display read/write speed
Use ▲or ▼ to select device
3.5 Quick Erase
Result: 00:00
Pass
：
7 Fail
：
0
Format
：
7
00:00 (00) Wait
[Utility]
2. Format exFAT
Sure to format?
Yes
[# 1] Read 20M
1sec Write 16.6M
[Utility]
4. Measure Speed
[# 0] Read 20M
1sec Write 16.5M
ENT
ENT
Format
：
7
00:00 (00) Wait
Format Process
ENT
[Utility]
3.Capacity Chec
k+Format
Sure to format?
Yes
Result: 00 : 02
Pass
：
7 Fail
：
0
Final result
