21
4. Setup
4.1 Copy Area
This option allows to select the area on the source device to copy onto the target devices. You may
select
System and Files
to skip all the unoccupied area on the source device or
Percentage
、
All
Partition
、
Whole Media
. By default, the copy area is set up as
System and Files
.
System and Files
The duplicator first analyzes the file format of source device. You may copy only the system and files
area to save overall copy time if the file format is FAT16, FAT32, exFAT, NTFS (Windows), EXT2,
EXT3, EXT4 (Linux), and HFS/HFS+/HFSX (Mac). For instance, the source device has 8GB
capacity but with only 50MB of data in FAT32 file format. The duplicator will copy only the 50MB of
data area to the target device, hence shortening overall copy time.
Percentage
When selected, the duplicator copies the selected percentage range. Users can set copy percentage
at this item. It has nothing with data or empty spaces.
All Partition
When select, the duplicator copies all partitions in the drive. It will not copy the area that have not
been partitioned.
Whole Media
When selected, the duplicator copies the entire content on the source device, including both the data
and empty spaces. This option is used when you have a source device with unknown file format.
For instance a source device has 8GB capacity and 50MB of data with unknown file format, the
duplicator will copy the whole 8GB of content to target device.
Use
▲▼to change option
▼
ENT
Sub menu
Copy Area menu
ENT
Main menu
[Copy Area]
System and Files
7. Setup
[Setup]
1. Copy Area
[Copy Area]
Whole Media
