II. Warning
1. The Green LED flashes during the execution process of a task. After the
task is done, the Green LED will stay solid if the process is successful,
otherwise the Red LED will be on if the process is failed.
2. DO NOT turn off the duplicator machine or remove the optical drive when
the task is under process. It may damage the duplicator or the optical drive.
3. DO NOT plug in USB flash drive until the duplicator boots up. It may cause
abnormal results if a USB flash drive with quality issue is plugged in during
boot up.
4. It is strongly recommended that the capacities of the source and target
media are equal or similar.
5. The media plugged into the source drive or source USB port will not be
overwritten (it is read only), avoiding the erase of the original data by accident.
III. Menu Overview
1. Copy
There are four (4) copy modes: 1. Disc to Disc; 2. USB to Disc; 3. Disc to USB;
4. USB to USB (3 and 4 only available on Media Maven Plus model).
1.1 Disc to Disc
This copy mode will copy the source disc placed in the designated source drive
to all target discs in the writer drives. This process writes all data contained on
the source disc to the target discs so the copies are exact the duplicates of the
source disc.
ENT
1. Copy
# 0 : No Disc => 0
[ Copy ]
1. Disc To Disc
[ Copy ]
2. USB To Disc
Press ENT button and get into
the 1
st
copy mode by default
Press
▼
or
▲
Button to select
different copy mode
No Disc is inserted
ENT
1. Copy
# 0 : No Disc => 0
[ Copy ]
1. Disc To Disc
Copy x 5 2048M
10% 8.9X 204M
ENT
Result :
Pass 5 Fail 0
x 5:
number of target discs
2048M
: source data capacity
10%:
rate of copy progress
8.9X:
writing speed
204M:
data copied so far
6
