12
In this mode, the duplicator will not analyze the master disk data. Before using this copy mode, you must
fully grasp the location and distribution of the master disk data, or only want to copy a specific area on the hard
disk.
Note: Before starting Percent Copy, user needs to set the percentage of data to be copied in the system
setting menu in advance.
※
Percent Copy Process
：
A.
Use the ▲ and ▼ keys to select "8. Setting" in the main menu, and press ENT key.
B. U
se the ▲ and ▼ keys to select "Set Copy Percent" under “8. Setting” menu, and press ENT key.
C.
Set percentage: use
▲
and
▼
keys to adjust the number (0 to 9) of each digit of percentage, and ENT key to
change the digit of percentage. Press ESC key to return to the main menu after setting.
"2.1%-> 52.2%" in the figure above indicates that the copied area is from 2.1% to 52.2% of the capacity of
the master disk.
D. Use the
▲
and
▼
keys to select
“
Percent Copy” in the main menu.
E. Press Start button (OK button) to start Percent Copy
Percent Copy Process:
(Use Copy Area from 18% to 37% as an example)
