18
7.2.8.3 COPY UNKNOWN (N)
This setting is used in some special areas when it is impossible to perform comprehensive data analysis. If
you select "Yes", the partitions of valid data cannot be analyzed in the quick copy, and the contents will be
copied. If you select No, the copy fails (the default is No).
7.2.8.4 ERASE PATTERN(00)
This setting is used to set the erase data format of the full-disk erase function. Different data such as 00, 5A,
A5, AA, FF, RDM (random value) can be selected to write to the target disks (the default value is 00).
7.2.8.5 SPEED MOD (AUTO)
Set the mode of the duplicator speed based on the hard disks used, which is 3Gb, 6Gb, and AUTO
respectively. It is recommended to select the AUTO mode for automatic matching (default is AUTO).
3Gb
: for slower hard disks
6Gb
: for higher speed hard disks
AUTO
: The duplicator will automatically recognize the hard disk and use the right mode
7.2.8.6 SET PASSWORD
Password settings for the duplicator to prevent operators from randomly setting parameters and causing
duplication errors.
