POOR BAR CODE SYMBOL QUALITY.
INCORRECT INTERFACES CONNECTION
INCORRECT CONFIGURATION SETUP
The Decoder CCD scanner is a simple device to install and use.
Therefore, most of the problems can be attribute to these areas:
The troubleshooting process may follow simple procedures as
below:
TROUBLE SHOOTING
In general, Keyboard interface is trouble free, but there are some
items to check if you are facing problems.
Most computers use XT/AT compatible keyboard. Therefore, Select
the proper cable for your computer.
Do you have the correct cable?
3. If the scanner can" GOOD " read, then proceed to check the
interfaces cabling connections.
.
if reading the bar code does not result in a " Good Read", then
there was a problem with either the scanning technique or the
interfaces configuration setting( Reset it to DEFAULT ).
.
2. Once the power is on, try to scan bar code samples at page: The
scanner will " Good Read" Beep and "Good Read" Flash When
the scanner is in default configuration.
1. First, make sure your scanner firmly connect with PC/ system
and should emit one long beep afterward. When the trigger
button is pressed, a flash red light should be visible.
-- GROUP 43 --
GENERAL PROCEDURES
KEYBOARD INTERFACES
PROBLEMS.
57
Summary of Contents for One shot
