12
2.
Press
. When “OFF” begins flashing, use
to select the desired hour and minute to turn off the heater.
Press
at any time to clear the digits and shut down
“OFF” timer.
3.
Press
again. When “18” begins flashing, use
to select the desired temperature for Monday.
4.
Press
again. When
“TUES” appears on the screen and “ON” begins flashing, use
to select the desired
hour and minute to turn on the heater for Tuesday.
5.
Press
again. When “OFF” begins flashing, use
to select the desired hour and minute to turn off the
heater for Tuesday.
6.
Press
again. When “18” begins flashing, use
to select the desired temperature for Tuesday.
7.
Repeat steps 1 to 6 to set the “ON/OFF” time and temperature for Wednesday, Thursday, Friday,
Saturday, and Sunday.
8.
Press
or
to finish, ensuring to aim the remote control at the receiver located in the middle of the
appliance. The appliance will
“beep” once to confirm your settings have been saved successfully.
Open window warning
If the room temperature decreases by 10 degrees within 3 minutes, the appliance will assume there is an open window
nearby. In order to conserve energy, the heater will automatically switch from High Heat to Low Heat, or if the heater is
already at Low Heat, it will turn off completely.
When switching from High Heat to Low Heat, the appliance will beep 3 times and the digital display will flash
“88” 3 times
before displaying the existing heating status.
When switching from Low Heat to Off, the appliance will beep 3 times and the digital display will flash
“88” continuously.
To
reset the heating function, see “operating remote control” section.
NOTICE
When the heater is first turned on, a slight odor may be present. This is normal and
won’t occur again unless the heater is un-used for a long period of time.
NOTICE
To improve operation,
aim
the remote control at the front of the fireplace.
DO NOT
press the buttons too quickly
. Give the unit time to respond to each command.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature, the heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet.
2. Turn the ON/OFF switch on the CONTROL PANEL to OFF.
Wait 5 minutes.
3. Inspect the fire unit and make sure all vents are free from dust or lint. If they are clogged, use a
vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If the problem continues, have your outlet and wiring inspected by a professional.
note:
If the temperature was previously set, those digits will be shown instead of
“18”.
Summary of Contents for Celestial 600
Page 17: ...17 ...
