14
Fuel-bed Effect Installation
1.
While supporting the glass, remove the screws holding the front glass screen in place. Remove
the glass and safely store it to one side for now.
See page 12.
2.
Disperse the crystals evenly on the fuel-bed tray in a side-to-side motion.
Figure 1.
Next, using
the same side-to-side technique, disperse most of the charred flakes onto the surface of crystals.
Save some for later.
3.
Place the artificial logs on the surface of the crystals, leaving a gap underneath so the fire effect
is visible.
Figure 2.
To enhance the bed further, disperse the remainder of the charred wood flakes in
and around each log.
4.
Finally, when content with your fuel-bed, re-fit the glass screen
See page 12
, switch the fire on
and relax.
Figure 1.
Figure 2.
Note:
The appliance must be installed in its final location before the crystals, artificial logs and charred
wood pieces are installed.
Summary of Contents for MZEFTCEL36
Page 24: ...24 ...
