M
AINTENANCE
37
Wheel Installation
NOTICE: To decrease the risk of component damage, do not tighten the lug nuts
to more than the specified torque.
Always install lug nuts using a cross sequence pattern to ensure the
even seating of the wheel against the hub.
1.
Install the wheel on the hub with lug nuts. Make sure the valve stem is to the out-
side.
2.
Finger tighten the lug nuts.
3.
Using the cross tightening pattern shown to the right, tighten the lug nuts to
. Tighten in increments of 20 ft. lbs. (27 Nm).
LIGHTS
• Clean the lights frequently to maximize visibility.
• Replace burned out bulbs promptly.
Do not operate this vehicle at night or in low light if any bulbs are burned out. Poor light-
ing reduces visibility that could cause an accident resulting in severe injury or death.
NOTICE: Replacement bulbs are available from a local Distributor, an authorized Branch or the Service Parts
Department.
Halogen Headlight Bulb Replacement
Light components can get hot if they have been in operation. Allow the lights to cool
before servicing to prevent burns to the skin.
NOTICE: Do not touch a halogen bulb with bare fingers. Oil from skin leaves a residue that causes a hot spot
and will diminish the life of the bulb.
1.
Disconnect the headlight harness from the headlight.
2.
Rotate the bulb 1/4-turn to remove the headlight bulb
from the housing.
3.
Insert and rotate the new bulb to lock into place.
4.
Connect the harness to the bulb.
LED Headlight Assembly Replacement (If
Equipped)
1.
Disconnect the headlight harness from the headlight.
2.
Remove the screws securing the headlight assembly to
the headlight bezel.
3.
Remove the headlight assembly and install the new
one with screws.
4.
Connect the harness to the headlight assembly.
Lug Nut Torque
65 - 85 ft.lbs. (88 - 115 Nm)
Lug Nut Tightening Pattern
Screw
Headlight Housing
or
LED Headlight
Assembly
Summary of Contents for Express L6 ELiTE
