Ezgo INDUSTRIAL 1000 2004 Owner'S Manual And Service Manual Download

Page: 22 / 130

OPERATION AND SERVICE INFORMATION

Page 6

Owner’s Manual and Service Guide

Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings

PLASTIC LOADBED

The manual lift bed is the standard bed for the vehicle.
The bed may be equipped with an optional electric lift
switch.

Failure to follow these

instructions may result

in personal injury, dam-

age the vehicle and/or cause the vehicle to tip over.

Operate the vehicle with awareness of the load. Read,

understand and follow the Danger label affixed to the

front of the loadbed.
Do not permit anyone to ride in the bed.
Before operating, check to ensure no one is behind

the vehicle.

A loadbed warning label is affixed to the inside front of
the bed (see Appendix A). This label must be understood
and observed at all times for safe operation of the vehi-
cle. See the loadbed warning label for maximum load.
The load must be positioned in the bed as far forward as
possible, distributed in such a way that its center of grav-
ity must not be higher than height noted on label, and
securely fastened down. Failure to follow these instruc-
tions may result in severe personal injury, damage the
vehicle and/or cause the vehicle to tip over. Operate the
vehicle with awareness of the load.
Do not permit anyone to ride in the bed.
Do not drive the vehicle with the loadbed raised or with
the tailgate unsupported.
When using the electric lift, be sure to avoid backing up
to the edge of a drop off, such as a loading dock or
ravine. A misjudgment of distance or an unstable surface
could result in the vehicle falling backwards.
Before operating, check to ensure no one is behind the
vehicle.

Never fill a gas can in the

bed of a vehicle. Static

discharge could ignite

gasoline vapor and cause an explosion.

Always place a gas can on the ground before filling.
Never fill a gas can in the bed of the vehicle. Static elec-
tricity is built up during the fueling process and could dis-
charge causing the gasoline vapor to ignite.

MANUAL LIFT BED OPERATION

Exercise caution while

operating the manual lift

bed to ensure the bed is

not released during lifting or lowering procedure.

Severe injury could result if bed is released and traps

fingers or other body parts.

To lift the manual lift bed, pull back on the latch release
handle immediately behind the driver seat (Ref. Fig. 13
on page 6). Raise the bed using the handle on the side of
the bed.

The gas strut will assist in raising the empty loadbed and
will keep the bed raised (Ref. Fig. 14 on page 7).

Over time, the gas strut may allow the loadbed
to slowly lower. If this condition is evident,

replacement of gas strut is required.

To lower the manual lift bed, grasp the bed handle and
lower the bed to the rest position.

Be sure hands are

not trapped by the bed.

TAILGATE OPERATION

To open the tailgate, lift tailgate straight up with a sharp
upward pull to lift out of the closed position and pivot out
for open position. To remove the tailgate, remove the

Fig. 12 Electric Lift Switch

Raise

Lower

Ref Lbs 1

Fig. 13 Manual Bed Latch

Ref Mbl 3

Front of Vehicle

Manual Load Bed Latch
Move Rearward to release