HA
-Page
7
-
FIREWIRE/USB 2
COMBO:
USB 2
MODEL:
USB 2.0
PORT
USB 2.0
PORT
FIREWIRE
PORT
POWER
PORT (IF NEEDED)
POWER
PORT (IF NEEDED)
FIREWIRE:
1. Attach Firewire cable to Firewire port on drive
2. Attach other end of Fireiwre cable to port on computer
NOTE: If your computer uses a 4-pin Firewire port you will need a 6-pin to 4-pin Firewire
cable (not included).
If your computer uses a 4-pin Firewire port, or if you system does not supply enough power
through the Firewire port you will need to use an external power supply.
USB 2.0:
1. Attach the Mini port end of the USB 2.0 cable to the USB 2.0 Port on the back of the drive.
2. Attach the 2 standard USB connectors to 2 USB ports on the computer, this will supply
enough power to run the drive off of bus power.
NOTE: If your computer only has 1 USB 2.0 port you will need to use an external power
supply.
1. Attach the Mini port end of the USB 2.0 cable to the USB 2.0 Port on the back of the drive.
2. Attach the 2 standard USB connectors to 2 USB ports on the computer, this will supply
enough power to run the drive off of bus power.
NOTE: If your computer only has 1 USB 2.0 port you will need to use an external power
supply.
If your system does not provide enough bus power to run the
drive, an external power adapter is available from EZQuest.
You can order one through your dealer by email at
sales@ezq.com, Part number is E59000.
SLIM DRIVE HARDWARE INSTALLATION
