EZSTEP EVO-PROLEAN Manual Download

Page: 34 / 112

ladder.Pull them all the way up until the
segment snaps into place.

This will continue until all rung segments

are fully extended. Those which you do not
use, are joined together above. At this point,
please check again if the locking bars extend
completely.

H) Now you need to check:

Are all the

extended rug segments also locked? Are all
locking latches fully extended? Important: the
locking buttons are at the second last rung
below. When the rung segments are locked,
these buttons point to the closed lock symbol.
If this does not happen immediately, jog a little
on the ladder until all the segments snap into
their corresponding locking position. If
everything is fixed, you can continue - just get
on the ladder!

E) Now you need to assemble:

For the ladder

to stand securely, it should be placed at
an¬ angle of 75 degrees to the ground.

3. How to slide the ladder together again

Did you finish your work? Then it´s time you
make long into short again. But be careful: If the
ladder became dirty during work, you
must clean the ladder before compacting it.

I) Important: Hold the ladder at the upper
range as well as on the outside of the
telescopic poles so that they DO NOT jam
your fingers when unlatching and compacting.
J)

Completely unlock the ladder: This is

performed with the locking buttons on the
second-last rung. Loosen each one of these
buttons one after the other. Use the other
hand to continue securing the telescopic
arms. You can make it easier if you release
the right locking button with the right and the
left one with the left.

Now as described under I) secure the ladder

at the upper part of the telescopic rods. Now
slide the ladder slowly and in a controlled
manner with both hands.The side parts of the
stabilisation bar can now be retracted. Press

the release buttons at the end of the strip and
push in the outriggers.

WATCH YOUR HANDS: One again, attention -
DO NOT place your hands between the rungs
when unlocking and compacting the ladder.

4. How to clean the ladder

First of all, in order for the ladder to remain
permanently safe and effective, you must keep
it clean, especially the telescopic rods and rung
segments. Therefore, wipe and wash off dirt,
paint, glue and other residue right after use AND
before compacting! As a rule, a cloth with a little
detergent is sufficient.

Tip:

After cleaning, you can apply silicone spray

to the telescopic bars. Simply extend the ladder,
spray it and dry it. The latter is important to
prevent dust from adhering.

5. How to transport and store the ladder

a) Transport
Important: Always transport the ladder in
compacted and upright condition, so that the
ladder cannot open. Do not transport it unless it
is completely compacted. This protects the
telescope bars from dents and damage. When
transporting them on a roof rack or loading
platform, make sure they are adequately secured.
b) Storage
Always store the ladder in a retracted and
compacted condition. Also, in a condition which
protects it from moisture and heat, as well as
from pollution. There should be no heavy objects
lying on it or leaning against it. Make sure that
the ladder is accessible, but does not become a
tripping hazard. If possible, secure it with a lock
from theft and, in the event it is installed
permanently, alsosecure it from unauthorised
access, for example, by children.