Find and mark the
exact location of
mounting holes.
Mark the exact
location of
mounting holes.
Drill pilot
holes.
Drill pilot
holes.
Screw the
wall plate
onto the
wall.
Screw the
wall plate
onto the
wall.
WARNING
WARNING
➔
Make sure that mounting screws are anchored into the centre of the studs.
Use of a stud fi nder is highly recommended.
➔
Installers are responsible to provide hardware for other types of mounting situations.
➔
The installer must verify that the supporting surface will safely support the
combined load of the equipment and all attached hardware (TV) and components.
➔
When installing wall mounts on cinder block, verify the actual concrete thickness
is at least 35mm for using the concrete anchors. Do not drill into mortar joints! Be
sure to mount in a solid part of the block, generally 25mm minimum from the side
of the block. It is suggested to use the electric drill on a slow setting to drill the hole
instead of a hammer drill to avoid breaking out the back of the hole when entering
a void or cavity.
➔
The installer must verify that the supporting surface will safely support the
combined load of the equipment and all attached hardware (TV) and components.
1a. Mounting on Timber Stud Walls
1b: Mounting on Solid Brick and Concrete Block
SLT-510 manual.indd 4-5
SLT-510 manual.indd 4-5
10/08/12 1:23 PM
10/08/12 1:23 PM
