F.Bertazzoni KU24 PRO 1XV, User Instructions

8

9

3LIOU1LG

3LIOU1LG

EN

waste pipe for the exhaust version, an air outlet 

with a diameter of Ø 160 mm (6”19/64) must be 

made through the wall.

WALL FIXING OF THE COOKER HOOD 

- INSTALLATION BY MEANS OF THE 

BRACKET SUPPLIED

1) Check the size of the model you have purchased 

(see picture 1).

2) When installing your product comply with the 

distance from the cooking (see picture 2).

3) Make a hole, for air circulation, inside of your 

furniture (see picture 3). 

4) Secure the aluminium flange to the hood with two 

screws (see picture 4).

5) Partially tighten the four screws holding the hood 

to the furniture, make two holes in the wall and insert  

the two dowels (see picture 5).

6) Remove the three metallic filters (see picture 6).

7) Place the hood in the four screws on the furniture 

(see picture 7).

8) Push the hood to the wall (see picture 8 step 1 and 

2),  lock the hood and tighten the four screws (see 

picture 8 step 3)

9) Insert and tighten the two locking screws to the 

wall (see picture 9).

10) Drill a hole for the passage of the air intake duct, 

insert the tube locking it with the clamp (see picture 

10).

CONNECTION EXHAUST

Link a 150 mm diameter air outlet chimney to the 

spigot. This pipe is an accessory of the hood.

Warning : To reduce the risk of fire use only metal 

ductwork.

Attention :

 The appliance is provided with a supply 

cord, the appliance must be positioned so that the 

plug is accessible.

Attention :

 If there are three wires in the electrical 

supply cable they must be connected as follows :

Grey/Yellow = ground - White = neutral - Black = line

Important : The hood manufacturer will 

not be responsible for any damage or 

loss caused by failure to observe these 

instructions.

Important : A damage power supply cord 

must be replaced by the service.

WARNING

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of 

an electrical short circuit , grounding reduces the 

risk of electric shock by providing an escape wire for 

electric current. This appliance is equipped with a 

cord having a grounding. The plug must be plugged 

into an outlet that is properly installed and grounded.

WARNING : Improper grounding can result in a risk 

of electrical shock.

Consult  a  qualified  electrician  if  the  grounding 

instructions are not completely understood, or if 

doubt exists as to whether the appliance is properly 

grounded.

Do not use an extension cord. If the power supply 

cord is too short have a qualified electrician install 

an outlet near the appliance.

USING THE COOKER HOOD

The cooker hood should be switched on either before 

or the same as cooking ot frying commences. The 

filters are more effective if the fan is not switched off 

immediately after cooking or frying is completed, but 

only after a period of some 20-30 minutes. Before 

using the cooker hood please ensure that all plastic 

films like on metal grease filter and stainless steel 

ducting are removed.

USER INSTRUCTION

The cooker hood is equipped of the following functions  

(see below) :

0

3 2 1

0

 -  Light OFF

1

 -  Light ON

   -  Pilot light

3

   -  Third speed (maximum)

2

   -  Second speed (medium)

1

 -  First speed (minimum)

0  

- Fan-off

LAMP REPLACEMENT

The hood has a halogen lamp, take care to not

touch with hands when you replace it. Use a dry and

not greasy protection (for example a cloth) in order

to avoid a direct contact with skin that could make

the lamp break. Never use lamps with wattage

higher than the one shown on the label inside the

hood.

SAFETY RULES

Do not do any dry flambè cooking underneath the 

hood. When frying, never leave the pan alone 

because the cooking oil could flare up. Clean all the 

surface frequently to avoid danger of fire. This can 

be done with a cloth or/and with a brush drenched 

with denatured alcohol or with any other similar 

substances, except for the button. It also important 

to remove and clean or substitute frequently the 

filter installed in the hood.

MAINTENENCE

NOTE : 

Prior to any maintenence, switch off and