TOP
-ino
User Manual
21 of
25
F+D
Feinwerk- und Drucktechnik GmbH
Kirchenstraße 38, D - 69239 Neckarsteinach, Germany
Phone: +49 6229 7000, Fax: +49 6229 70067
E-Mail: hotline@fuddruck.de, Internet: http://www.fuddruck.de
6.2 Improvement of the print
quality
1. Print too light or rich in contrast
In order to guarantee a constant quality in printing only
sublimation ribbon recommended by the manufacturer should
be used.
The corresponding parameter may be set in the printer driver.
Read the operation manual for the printer driver
2. Individual Small Areas of not Printed or Printed Incorrectly in
Color
This deals with dirt particles which were not removed from the
cleaning rolls or the card material is uneven.
The cleaning rolls have to be cleaned immediately.
3. The Card Edges are not being Printed Evenly
There is a “Ridge“ on the card edges.
You should insert different cards or not print all the way to the
edge.
Note:
The „Ridge“ normally is only on one side. Change the
front- and backside)
4. Change in Print Quality after Change the Sublimation Ribbon
After insertion of a new color ribbon (according to the
specification of the manufacturer) the contrast decreases while
printing.
-The ribbon is outdated
-The print parameter must be changed.
5. Horizontal Lines
White or black lines straight through appear, individual dots are
not printed. Should the error re-appear after cleaning the
thermal head , thus the thermal head is defect and must be
exchanged.
6. Vertical Streaks
If it deals with two light streaks in the distance of 3 mm the
cleaning rolls should be cleaned before you are starting to work.
7. After Changing the Card Material the Print Quality Changes.
The printer parameter must be installed according to the card
material. Only use card material recommended by
F+ O.
8. Printer Offset
When printing the test card an offset of the color lines is
observed (Y,M,C). please clean the transport rolls by spirit.
Summary of Contents for TOP-ino
Page 2: ......
