TOP
-ino
User Manual
5 of
25
F+D
Feinwerk- und Drucktechnik GmbH
Kirchenstraße 38, D - 69239 Neckarsteinach, Germany
Phone: +49 6229 7000, Fax: +49 6229 70067
E-Mail: hotline@fuddruck.de, Internet: http://www.fuddruck.de
2. Getting Started
2.1 Preparation of the place
of installation
The installation area must be even and stable. Make sure that
there is enough space:
- to be able to connect the cables,
- that air may circulate through the ventilation slits.
The printer must be applied according to application conditions
concepted for it (see 8.).
The case or even the internal parts of the printer may never get
in contact with any liquid.
2.2 Unpacking
After removing the packing material from the printer check the
contents of the carton:
- Printer
TOP-
ino
- Power Cable (DIN-standard)
- Centronics Cable
- Sublimation Ribbon (YMCKO for 250 cards) with an
empty spool
- Card Support Weight
- 2 cleaning rolls
- Card Output Plate
- Spherical Typehead Screwdriver
- Operating Instructions
- Diskette with the printer software and the print head
parameters
- Printer Driver (diskette) with installation manual
2.2 Connecting the power
On the backside of the
TOP-
ino
are the connectors and the
power switch.
1. Switch Off the power switch (“O“ must be switched
down).
2. Connect the power cable (pay attention to a tight fitting)
and only use a grounded wall outlet socket.
The change of the power to 110 V is automatically.
3. Switch On the
TOP-
ino
(“1“ must be switched down).
Summary of Contents for TOP-ino
Page 2: ......
