- 16 -
Confirm with CENTER
Now the third value F=1234 Hz
is memorized in bank #1.
Hint for entering of frequencies:
-
Before confirming with CENTER, a wrong entry can be erased to
F = 0 with KEY-LEFT
-
With KEY-UP
values are incremented.
-
With KEY-DOWN
values are decremented.
Start program with
Start a user defined application
The F-SCAN COMPACT DUO offers 100 memory banks of 50 positions
each.
If the program is started with “F1”, both generators output the same
frequency in sequences one by one.
DUO MODE
When a user defined application is started with CENTER, the program
follows the DUO MODE principle. This means, that the first frequency “F1” of
a program outputs the signal on the red wire of the cable FTB033. The
second frequency indicated as “F2” is output at the black wire of the
application cable. The blue wire is the reference of both generators.
It is possible to use the red and black wire only to receive a mixed signal of
F1 and F2. But the reference on the blue wire is necessary to measure the
conductivity.
In DUO MODE, the maximum of 50 frequencies per memory bank (… per
program) is divided by 2 because always two frequencies run
simultaneously. The conductivity is measured for both output signals.
Although the conductivity is measured in microamperes, the indication is in
CV (conductivity value). The reason is that at low frequencies, the
measurement of microamperes can be inaccurate.
