Cable Requirements
ARX Hardware Reference Guide
3 - 15
are for connection to Ethernet over fiber-optic cable.
Important
Fiber-optic ports are shipped with SFP optics installed. These ports must be
protected by a rubber grommet filler or a cable connector at all times to
prevent dust from collecting in the transceiver.
Figure 3.3
Rubber grommet filler or a cable connector
ARX-500 Connectors
The ARX-500 has four rear-panel ports for cabling, as shown in the
following figure.
Figure 3.4
ARX-500 rear-panel ports
The following table describes the cable connectors used on the ARX-500.
Table 3.13
ARX-500 Cable Connectors
Interface
Connector
Purpose
serial console
(labeled 10101)
RJ-45
Serial port for CLI access
OOB management
(labeled 2)
RJ-45
100/1000 BASE-T Ethernet
(copper) port for CLI access
Summary of Contents for ARX-500
