Powering On the Switch
ARX-500 Hardware Installation Guide
2 - 9
On the rear panel of the switch, plug the power cord into the power
connector shown in the following figure.
Figure 2.4
Power Cord Connector (Rear View)
See
Power Cord and Cable Requirements, on page 4-5
for power cord and
cable specifications.
Powering On the Switch
WARNING
Before applying power, ensure that the AC outlet to the switch is properly
grounded.
To power on the switch, press the power button on the front control panel of
the switch. This illuminates the power LED above the button.
Cabling
Ethernet cables are supplied by the customer. For cable specifications and
requirements, see
Power Cord and Cable Requirements, on page 4-5
. For
cable connector and pinout information, see
Cable Connectors and Pinouts,
on page 4-6
.
The ARX-500 has four rear-panel ports for cabling, shown below:
serial console port
OOB management port
client/server, port 1/1
redundancy link, port 1/2
Summary of Contents for ARX-500
